**DUE TO COVID19 - OUT OF STOCK TILL END OF 2020**
*Contact us for availability
Ships in 1-5 business days
The GTC-R pop up hub was developed especially for competition cars. Any steering wheel and steering boss matching a 3-hole 50.8mm PCD attachment style will comply with this pop up hub.
The GTC-R pop up steering system has a 50.8mm PCD pattern which is smaller than commonly sized 70mm/74mm PCD (MOMO/Sparco/Nardi/Personal/etc.). Because of this, a 3-hole to 6-hole adapter (x2) are required if you wish to adapt a 70mm/74mm PCD steering wheel and steering boss hub into your street car. This adapter has dual 70-74mm PCD hole patterns.
We highly suggest going with a RAPFIX GTC Hybrid Pop Up Hub or Rapfix GTC Tilt System instead as its more cost efficient if you wish to use the commonly larger 70mm & 74mm PCD patterned steering wheel and steering bosses.
ProgressThis product is developed for the race, in which driver changing takes place. Instead of attaching and detaching the Quick Release products, bouncing the steering wheel (tilt up) is much easier to complete driver-changing action. In order to meet the need, Works Bell renewed the Rapfix GTC which was released for cars designed for street use and created the Rapfix GTC-R as a special parts used for competition.MechanicsWorks Bell also designed a new big lever for the GTC-R. Pull this big lever and tilt up the socket of steering wheel side from the plug in car side. Suspend function for stopping at any angles and hold function for avoiding lever operation during tilting down are equipped. Tilting down the steering wheel can complete locking. Precision steel balls can fit the two holes grooved in the plug and the taper holes set up in the socket. Perfect combination is finished by the power of coil spring loaded on the sleeve arm.CharacteristicsBy using the Ball Lock System, smooth hinge action and lock without shakiness are realized. The precision steel balls used for ball bearing fit the two holes grooved in the plug attached on the car side. It is locked definitely without any shakiness when tilting down. Rapfix GTC solved the problem of shakiness and play by using the Ball Lock System. Therefore, it plays a big part in the driver’s severe steering wheel operation.SpecificationsThe GTC-R is developed specifically for competition cars. Three PCD50.8mm M5P0.8 screw holes are stored in the installation side of the plug that is attached to the car side. The same Six PCD50.8mm M5P0.8 tap holes are stored in the installation side of the steering wheel. Two electric points are set up for option in order to correspond to various electric functions. Furthermore, wiring is set up on the installation side of the steering wheel in order to fulfill the convenience.StrengthThe NAPAC standard test (a standard for after market products in Japan) has been done. A screwing test was done to check the operation of steering wheel to radial power. There was not any change in the shape after being pounded by dead loads of 29.7kg.m (291N.m). Moreover, there was not any change in the shape after a bending test of dead loads of 19.8kg.m (194N.m) in order to examine the effect when a driver impacts the top of the steering wheel in an accident.According to the results of these tests, although the bending test caused the permanent transformation, it is possible to tilt up. Furthermore, the screwing test based on regulation loads did not cause any problems. Also, in order to know the limitation of tilting up, bending loads 38kg.m (372N.m) was given, although it stretched a lot, it was not broken and it is still possible to operate.Moreover, 30,000 times of tilting up and tilting down operation in order to check the endurance was tested at the Works Bell factory. They have confirmed that it is possible to operate 30,000 times without changing parts although it was necessary to smooth the parts with oil during the test.